Toshiba e-STUDIO5540C Service Manual page 66

Check item
Other
Replace parts
Paper clinging detection sensor
Registration motor
PFC board
LGC board
Rollers
[E030] Power-ON jam
Classification
Other paper jam
Check item
Transport path
Sensor
PFC board
Replace parts
Sensor in the jamming area
PFC board
ADU board
Jamming area Cover
Paper path section Duplexing unit
Fuser Duplexing unit
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
Check if there is any paper clinging to the transfer belt or
entering under the receiving tray. Remove it if there is.
Use the paper within the specification if the thin paper being
used is out of specification.
The paper is remaining on the paper transport path when
power is turned ON.
Open the cover, and then remove paper if there is any paper
on the transport path.
Sensor check (Refer to the table below)
Connector check
Harness check
Connector check
(CN500, CN505, CN506, CN509, CN511, CN512, CN513,
CN515)
Harness check
Board check
Refer to the table below
Sensor
Registration sensor
Transfer belt paper clinging
detection sensor
2nd transfer side paper
clinging detection sensor
1st drawer transport sensor
Fuser transport sensor
Reverse path sensor
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
8 - 65
Measures
Remarks
Error item
Measures
Remarks
Test Mode/Input check
03-[ALL]OFF/[4]/[B]
03-[COPY]ON/[5]/[H]
03-[ALL]OFF/[9]/[C]
03-[ALL]OFF/[9]/[D]
03-[SCAN]ON/[1]/[D]
03-[ALL]OFF/[2]/[C]
03-[COPY]ON/[5]/[F]
03-[ALL]OFF/[1]/[C]
03-[SCAN]ON/[3]/[E]
ERROR CODE and TROUBLESHOOTING
8