Toshiba e-STUDIO5540C Service Manual page 154

Check item
Hole punch control PC board (HP)
Replace parts
Hole punch control PC board
[CC80] Rear alignment motor abnormality
Classification
Finisher related service call
Check item
Rear alignment plate
Rear alignment motor (M10)
Finisher control PC board (FIN)
Replace parts
Rear alignment motor
Finisher control PC board
[CDE0] Rear alignment motor abnormality
Classification
Finisher related service call
Check item
Paddle
Paddle motor (M8)
Finisher control PC board (FIN)
Replace parts
Paddle motor
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
• Download the latest version of the PNC board (HP)
firmware again and then check its operation.
• Connector check
• Board check
The rear alignment motor is not rotating or the rear alignment
plate is not moving normally. [MJ-1103/1104]
You receive a [CC80] error when the [ED14] error occurs
three times in succession.
• Is there any mechanical problem when the rear alignment
plate is moved?
• Motor check
• Connector check
• Harness check
• Connector check (CN17)
• Board check
The paddle motor is not rotating or the paddle is not rotating
normally. [MJ-1103/1104]
You receive a [CDE0] error when the [ED15] error occurs
three times in succession or during the initial operation.
• Is there any mechanical problem with the paddle is
rotated?
• Motor check
• Connector check
• Harness check
• Connector check (CN6)
• Board check
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
8 - 153
Measures
Remarks
Error item
Measures
Remarks
Error item
Measures
Remarks
ERROR CODE and TROUBLESHOOTING
8