Toshiba e-STUDIO5540C Service Manual page 151

Check item
Stack transport roller-1/-2
Transport motor (M2)
Finisher control PC board (FIN)
Replace parts
Transport motor
Finisher control PC board
[CC41] Paper holder cam home position abnormality
Classification
Finisher related service call
Check item
Paper holder cam
Paper holder home position sensor
(S6)
Finisher control PC board (FIN)
Replace parts
Paper holder home position sensor
Finisher control PC board
[CC51] Sideways adjustment motor (M2) abnormality
Classification
Finisher related service call
Check item
Sideways adjustment motor (M2)
Sideways deviation home position
sensor (S3)
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
ERROR CODE and TROUBLESHOOTING
• Is there any mechanical problem when the stack transport
roller -1 and -2 are rotated?
• Motor check
• Connector check
• Harness check
• Connector check (CN5)
• Board check
The paper holder cam is not at the home position. [MJ-1103/
1104]
• Is there any mechanical problem when the paper holder
cam is rotated?
• Sensor check
• Connector check
• Harness check
• Connector check (CN17)
• Board check
Sideways adjustment motor is not rotating or puncher is not
shifting normally. [MJ-6102]
The [CC51] error will be displays when the [ED11] error
occurs three times in succession or during the initial
operation.
• Motor check
• Connector check
• Harness check
• Sensor check
• Connector check
• Harness check
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
8 - 150
Measures
Remarks
Error item
Measures
Remarks
Error item
Measures