Toshiba e-STUDIO5540C Service Manual page 615

Sub
05/08 Mode Element
element
08 Setting System User
mode interface
08 Setting System FAX
Mode
08 Setting System User
mode interface
08 Setting System General
Mode
08 Setting System User Card reading device
Mode interface
08 Setting System User Card reading device
Mode interface
08 Setting System User Card reading device
Mode interface
08 Setting System User Card reading device
Mode interface
08 Setting System User Card reading device
Mode interface
e-STUDIO5540C/6540C/6550C (Ver08)
Sub-
Item Subitem Code
code
8628
8631
8640
8641
LDAP authentication 8642
LDAP authentication 8643
LDAP authentication 8644
LDAP authentication 8645
LDAP authentication 8646
Default Acceptable
Details
value value
Job operation on the 0 0-1
COPY screen when
the coin controller is
connected
Filename creation at 0 0-1
fax reception and
forwarding
Job build operation 0 0-1
when the coin
controller is
connected
Notification setting for 1 0-1
job cancel
LDAP attribute name eBMUse -
settings 2 rCard
LDAP attribute name eBMUse -
settings 3 rCard
LDAP attribute name eBMUse -
settings 4 rCard
LDAP attribute name eBMUse -
settings 5 rCard
LDAP attribute name eBMUse -
settings 6 rCard
208
RAM Contents
SYS This setting enables user to move from the COPY
screen to JOB STATUS screen, and then operate jobs
during printing when the coin controller is connected.
This code is valid when the value of 08-9016 is "1".
0: Disabled
1: Enabled
SYS 0: Use address name (family-name/first-name) as
filename if multiple names are found by address book
search of TSI (sender information).
1: Use address name (family-name/first-name) as
filename only when single name is found by address
book search of TSI (sender information).
SYS This setting enables user to use the job build function
when the coin controller is connected. This code is valid
when the value of 08-9016 is "1".
0: Disabled
1: Enabled
SYS Sets the notification setting for job cancel. This setting
is effective for the following codes:
1CC0, 2BB0, 2CC0, 2DC0, 2EC0
0: Disabled (Not notified)
1: Enabled (Notified)
SYS Maximum 32 characters (ASCII).
SYS Maximum 32 characters (ASCII).
SYS Maximum 32 characters (ASCII).
SYS Maximum 32 characters (ASCII).
SYS Maximum 32 characters (ASCII).
Proce Servic
dure e UI
1
1
1
1
11
11
11
11
11