Toshiba e-STUDIO5540C Service Manual page 90

Replace parts
Entrance sensor (S1)
Transport sensor (S2)
Entrance motor (M1)
Finisher controller board
[EA25] Paper transport jam in Finisher (after paper stack was exited)
Classification
Finisher jam
(Finisher section)
Check item
Finisher
Finishing tray paper detection sensor
(S12)
Finisher controller board
Replace parts
Finishing tray paper detection sensor
(S12)
Finisher controller board
[EA26] Paper transport jam in Finisher (Stop signal received from equipment)
[EA27] Paper transport jam in Finisher (Paper not inserted but paper detected)
Classification
Finisher jam
(Finisher section)
Check item
Finisher
Entrance sensor (S1)
Finisher controller board
Replace parts
Entrance sensor (S1)
Finisher controller board
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
[MJ-1103/1104]
• Check if there is any paper in the finisher or on the
transport path of the equipment and remove it if there is.
• Sensor check
• Connector check
• Harness check
• Connector check(CN18)
• Board check
[MJ-1103/1104]
• Check if there is any paper in the finisher or on the
transport path of the equipment and remove it if there is.
• Sensor check
• Connector check
• Harness check
• Connector check(CN26)
• Board check
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
8 - 89
Remarks
Error item
Measures
Remarks
Error item
Measures
Remarks
ERROR CODE and TROUBLESHOOTING
8