Toshiba e-STUDIO5540C Service Manual page 642

Sub
05/08 Mode Element
element
08 Setting System General
Mode
08 Setting System Initializatio
Mode n
08 Setting System User Counter installed
Mode interface externally
08 Setting System Maintenan General
Mode ce
08 Setting System User Screen setting
Mode interface
e-STUDIO5540C/6540C/6550C (Ver08)
Sub-
Item Subitem Code
code
9022
9030
9037
9050
9051
Default Acceptable
Details
value value
Production process 99 0-99
management status
for easy setup
Initialization after - -
software version up
Job handling-short 1 <0-1>
paid-coin controller
Performing panel - -
calibration
Panel calibration 0 <0-1>
setting value
235
RAM Contents
SYS Perform this code when an error occurs during the easy
setup (unpacking manual adjustment) and you want to
finish the easy setup, or when the error is canceled and
you want to restart the unpacking manual adjustment.
0: Unpacking mode finished (before unpacking is
started)
1: Auto-toner adjustment finished
2: Sub-hoppers and toner cartridges are installed
3: Confirmation of installation of sub-hoppers and toner
cartridges is finished
4: Forcible image quality control finished
5: Forcible image position alignment finished
6: Automatic gamma adjustment (PPC) finished
7: Automatic gamma adjustment (PRT, 600 dpi)
finished
8: Automatic gamma adjustment (PRT, 1200 dpi)
finished
99: All the unpacking adjustments finished
Only 0 to 8 and 99 are available for this code.
SYS Perform this code when the software in this equipment
has been upgraded.
SYS Sets whether pause or stop the printing job when it is
short paid using a coin controller.
0: Pause the job
1: Stop the job
SYS Performs the calibration of the pressing position on the
touch panel (LCD screen).
The calibration is performed by pressing 4 reference
positions after this code is started up.
SYS Switches whether the screen for displaying panel
calibration setting values is displayed or not.
0: Disabled (screen not displayed)
1: Enabled (screen displayed)
Proce Servic
dure e UI
1
3 Yes
1 Yes
1 Yes
1 Yes