Toshiba e-STUDIO5540C Service Manual page 576

Sub
05/08 Mode Element
element
08 Setting Counter Threshold C toner
Mode for nearly
empty
08 Setting Counter Threshold C toner
Mode for nearly
empty
08 Setting Counter Threshold C toner
Mode for nearly
empty
08 Setting Counter Counter Sub-hopper toner
Mode motor driving time
counter
08 Setting Counter Counter Sub-hopper toner
Mode motor driving time
counter
08 Setting Counter Counter Sub-hopper toner
Mode motor driving time
counter
08 Setting Counter Counter Sub-hopper toner
Mode motor driving time
counter
08 Setting Counter General
Mode
08 Setting Counter Developm Toner / carrier supply
Mode ent motor driving time
counter display
e-STUDIO5540C/6540C/6550C (Ver08)
Sub-
Item Subitem Code
code
6454
6454
6454
6466
6466
6466
6466
6467
6469
Default Acceptable
Details
value value
4 Threshold to display 830 8 digits
the near empty
message (longer)
5 Threshold to display 900 8 digits
the near empty
message (shorter)
6 Remaining level 935 8 digits
threshold: 0
0 Y 0 8 digits
1 M 0 8 digits
2 C 0 8 digits
3 K 0 8 digits
Number of output 2 0-7
pages available at
toner cartridge
replacement (during
cover open)
0 Y 0 8 digits
169
RAM Contents
M Sets the timing for when the toner near empty display
appears.
The period of time (number of counts) from the
appearance of the near empty display to actually
running out of toner is longer (larger) than that of
"center".
The larger the value, the later the display appears.
[Unit: 1 count = 500 ms]
M Sets the timing for when the toner near empty display
appears.
The period of time (number of counts) from the
appearance of the near empty display to actually
running out of toner is shorter (smaller) than that of
"center".
The larger the value, the later the display appears.
[Unit: 1 count = 500 ms]
M Sets the timing for when the toner remaining level is 0%
appears.
[Unit: 1 count = 500 ms]
M Counts the drive count of each sub-hopper toner motor.
M Counts the drive count of each sub-hopper toner motor.
M Counts the drive count of each sub-hopper toner motor.
M Counts the drive count of each sub-hopper toner motor.
SYS 0: 01: 1002: 2003: 5004: 10005: 15006: 20007: No
limitation(99999999)[Unit. page]
M Counts the driving time of each sub-hopper toner motor.
This value is the accumulation since the start of use or
the last replacement of developer material.
Proce Servic
dure e UI
4 Yes
4 Yes
4
4
4
4
4
1
4