Toshiba e-STUDIO5540C Service Manual page 530

Sub
05/08 Mode Element
element
08 Setting Counter Paper Feeding retry counter
Mode feeding
08 Setting Counter Paper Feeding retry counter
Mode feeding
08 Setting Counter Paper Feeding retry counter
Mode feeding
08 Setting Counter Feeding
Mode system /
Paper
transport
e-STUDIO5540C/6540C/6550C (Ver08)
Sub-
Item Subitem Code
code
6233
6234
6235
6236
Default Acceptable
Details
value value
4th drawer 0 <8 digits>
Bypass feed 0 <8 digits>
T-LCF 0 <8 digits>
Feeding retry counter 10 8 digits
upper limit value(1st
drawer)
123
RAM Contents
M Counts the number of times of the feeding retry from
the 4th drawer.
M Counts the number of times of the feeding retry from
the bypass tray.
M Counts the number of times of the feeding retry from
the T-LCF.
M When the number of feeding retry (08-6230 to 08-6235)
exceeds the setting value, the feeding retry will not be
performed subsequently. In case "0" is set as a setting
value, however, the feeding retry continues regardless
of the counter setting value.
In this equipment, a toner image is formed on the
transfer belt prior to a paper feeding.When the feeding
retry occurs and the transport timing is delayed, the
toner image on the transfer belt is cleaned off without
the 2nd transfer since the paper cannot be reached for
the 2nd transfer process.After that, the toner image
formation is retried while the paper is waited.In this
case, the toner for this image formation is consumed
wastefully since the toner image on the transfer belt is
already cleaned off, even though the printing is normally
completed.Therefore, note that the excessive toner will
be consumed consequently when the upper limit value
of feeding retry counter is set larger or set as "0" (no
limit).The toner is also consumed wastefully when the
paper misfeeding occurs. Replace the roller at earlier
timing if the paper misfeedings have occurred
frequently.
Proce Servic
dure e UI
1 Yes
1 Yes
1 Yes
1