Toshiba e-STUDIO5540C Service Manual page 100

[ED12] Shutter home position error
Classification
Finisher jam
Check item
Shutter
Shutter opening/closing sensor (S4)
Shutter clutch (CLT1)
Finisher controller board
Replace parts
Shutter opening/closing sensor (S4)
Shutter clutch (CLT1)
Finisher controller board
[ED13] Front alignment plate home position error
Classification
Finisher jam
Check item
Front alignment plate
Front alignment plate home position
sensor (S7)
Front alignment motor (M9)
Finisher controller board
Replace parts
Front alignment plate home position
sensor (S7)
Front alignment motor (M9)
Finisher controller board
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
The shutter is not at the home position. [MJ-1103/1104]
• Open and close the shutter. If there is any mechanical
problem, fix its mechanism.
• Rotate sideways adjustment motor and fix its mechanism
if it does not rotate smoothly.
• Motor check
• Connector check
• Harness check
• Clutch check
• Connector check
• Harness check
• Connector check
• Board check
The front alignment plate is not at the home position. [MJ-
1103/1104]
• Move the front alignment plate. If there is any mechanical
problem, fix its mechanism.
• Sensor check
• Connector check
• Harness check
• Motor check
• Connector check
• Harness check
• Connector check
• Board check
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
8 - 99
Error item
Measures
Remarks
Error item
Measures
Remarks
ERROR CODE and TROUBLESHOOTING
8