Replace parts
Finisher control PC board
[CE00] Communication error between finisher and punch unit
Classification
Finisher related service call
Check item
Hole punch control PC board (HP)
Finisher control PC board (FIN)
Replace parts
Hole punch control PC board
Finisher control PC board
[CF10] Communication module SRAM reading failure
Classification
Finisher related service call
Check item
Equipment
Setting
Finisher control PC board (FIN)
Hole punch control PC board (HP)
Replace parts
Finisher control PC board
Hole punch control PC board
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
ERROR CODE and TROUBLESHOOTING
Communication error between finisher controller PC board
and punch controller PC board.
[MJ-1103/1104 (when MJ-6102 is installed)]
•
Connector check
•
Board check
•
Connector check
•
Board check
•
Is the error recovered when the power of the equipment is
turned OFF and then back ON?
•
Check if the MJ-1103/1104 is set as the specified finisher
on the equipment. (08-4548="1")
•
Connector check
•
Board check
•
Connector check (when MJ-6102 is installed)
•
Board check
(when MJ-6102 is installed)
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
8 - 154
Remarks
Error item
Measures
Remarks
Error item
Measures
Remarks