Toshiba e-STUDIO5540C Service Manual page 95

[EAA0] Power-ON jam
Classification
Finisher jam
(Saddle stitcher section)
Check item
Finisher, saddle stitcher
No. 1 paper sensor (PI18)
No. 2 paper sensor (PI19)
No. 3 paper sensor (PI20)
Vertical path paper sensor (PI17)
Delivery sensor (PI11)
Saddle stitcher controller board
Replace parts
No. 1 paper sensor (PI18)
No. 2 paper sensor (PI19)
No. 3 paper sensor (PI20)
Vertical path paper sensor (PI17)
Delivery sensor (PI11)
Saddle stitcher controller board
[EAB0] Paper transport stop jam
Classification
Finisher jam
(Saddle stitcher section)
Check item
Finisher, saddle stitcher
No. 1 paper sensor (PI18)
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
ERROR CODE and TROUBLESHOOTING
Paper exists at No.1 paper sensor, No. 2 paper sensor, No.3
paper sensor, vertical path paper sensor or delivery sensor
when power is turned ON. [MJ-1104]
• Check if there is any paper in the finisher, saddle stitcher
or the on the transport path of the equipment. Remove it if
there is.
• Sensor check
• Connector check
• Harness check
• Sensor check
• Connector check
• Harness check
• Sensor check
• Connector check
• Harness check
• Sensor check
• Connector check
• Harness check
• Sensor check
• Connector check
• Harness check
• Connector check(J10, J13)
• Board check
The paper which passed through the inlet sensor does not
reach or pass No.1 paper sensor, No. 2 paper sensor, No.3
paper sensor or delivery sensor. [MJ-1104]
• Check if there is any paper in the finisher, saddle stitcher
or the on the transport path of the equipment. Remove it if
there is.
• Sensor check
• Connector check
• Harness check
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
8 - 94
Error item
Measures
Remarks
Error item
Measures