Toshiba e-STUDIO5540C Service Manual page 110

Check item
Finisher
Paper position sensor (S6-1/S6-2)
Punch controller board
Replace parts
Paper position sensor (S6-1/S6-2)
Punch controller board
[EF27] Hole Punch Unit paper edge detection order abnormality-1
[EF28] Hole Punch Unit paper edge detection order abnormality-2
Classification
Finisher jam (Saddle section)
Check item
Finisher
Skew sensor (S7-1/S7-2)
Punch controller board
Replace parts
Skew sensor (S7-1/S7-2)
Punch controller board
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
• Is there any paper remaining on the paper transport path?
Is it staying at the position shown below?
Paper
• Figure out the cause of the paper stopping (e.g. folding)
and correct it. Then remove the paper.
• Remove paper dust or punches on the paper position
sensor (S6-1, S6-2).
• Sensor check
• Connector check
• Harness check
• Connector check (CN19)
• Board check
• Is there any paper remaining in the paper transport path in
the equipment or the Finisher?
• Sensor check
• Connector check
• Harness check
• Connector check
• Board check
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
8 - 109
Measures
Skew sensor
(S7-1, S7-2)
Paper position sensor
(S6-1, S6-2)
Skew sensor
(S7-1, S7-2)
Remarks
Error item
Measures
Remarks
ERROR CODE and TROUBLESHOOTING
8