Toshiba e-STUDIO5540C Service Manual page 108

[EF22] Hole Punch Unit paper leading edge detection abnormality
Classification
Finisher jam (Saddle section)
Check item
Finisher
Paper position sensor (S6-1/S6-2)
Punch controller board
Replace parts
Paper position sensor (S6-1/S6-2)
Punch controller board
[EF23] Hole Punch Unit paper alignment abnormality
Classification
Finisher jam (Saddle section)
Check item
Finisher
Sideways deviation home position
sensor (S3)
Paper position sensor (S6-1/S6-2)
Sideways adjustment motor (M2)
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
• Is there any paper remaining on the paper transport path?
Is it staying at the position shown below?
Paper
• Figure out the cause of the paper stopping (e.g. folding)
and correct it. Then remove the paper.
• Sensor check
• Connector check
• Harness check
• Connector check (CN19)
• Board check
• Is there any paper remaining in the paper transport path in
the equipment or the Finisher?
• Sensor check
• Connector check
• Harness check
• Sensor check
• Connector check
• Harness check
• Motor check
• Connector check
• Harness check
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
8 - 107
Error item
Measures
Skew sensor
(S7-1, S7-2)
Paper position sensor
(S6-1, S6-2)
Skew sensor
(S7-1, S7-2)
Remarks
Error item
Measures
ERROR CODE and TROUBLESHOOTING
8