Toshiba e-STUDIO5540C Service Manual page 88

Check item
Finisher control PC board (FIN)
Replace parts
Entrance sensor (S1)
Finisher control PC board (FIN)
[EA21] Paper size error jam
Classification
Finisher jam
(Finisher section)
Check item
Finisher
Entrance sensor (S1)
Transport sensor (S2)
Finisher controller board
Replace parts
Entrance sensor (S1)
Transport sensor (S2)
Finisher controller board
[EA22] Short length paper jam in Finisher (paper position sensors S6-1/2)
Classification
Finisher jam
(Finisher section)
Check item
Finisher
Paper position sensor (S6-1)
Paper position sensor (S6-2)
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
• Board check
• Connector check (CN26)
• Harness check
Paper does not reach the sensor because the paper is
shorter than spec. [MJ-1103/1104]
• Check if there is any paper in the finisher or on the
transport path of the equipment and remove it if there is.
• Is the paper size used shorter than the size specified in
the specifications?
• Sensor check
• Connector check
• Harness check
• Sensor check
• Connector check
• Harness check
• Connector check (CN7, CN22)
• Board check
[MJ-1103/1104]
• Check if there is any paper in the finisher or on the
transport path of the equipment and remove it if there is.
• Use paper accepted in the specifications.
• Sensor check
• Connector check
• Harness check
• Sensor check
• Connector check
• Harness check
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
8 - 87
Measures
Remarks
Error item
Measures
Remarks
Error item
Measures
ERROR CODE and TROUBLESHOOTING
8