Toshiba e-STUDIO5540C Service Manual page 750

Sub
05/08 Mode Element
element
05 Adjustmen Scanner RADF Leading edge position
t mode adjustment
05 Adjustmen Scanner RADF Leading edge position
t mode adjustment
05 Adjustmen Scanner Scanner Carriage position
t mode adjustment during
scanning from RADF
(black)
05 Adjustmen Scanner Scanner Carriage position
t mode adjustment during
scanning from RADF
(color)
05 Adjustmen Scanner Scanner Data transfer of
t mode characteristic value
05 Adjustmen Scanner Scanner Data transfer of
t mode characteristic value of
scanner / SYS board -
> SLG board
05 Adjustmen Scanner RADF
t mode
05 Adjustmen Scanner Scanner Shading correction
t mode plate
Automatic dust
detection adjustment
05 Adjustmen Scanner RADF EEPROM initialization
t mode
e-STUDIO5560C/6560C/6570C (Ver08)
Sub-
Item Subitem Code
code
3044
3045
3046
3047
3203
3209
3210
3218
3220
Default Acceptable
Details
value value
Front side 50 0-100
Back side 50 0-100
Carriage position 128 0-255
adjustment during
scanning from RADF
(black)
Carriage position 128 0-255
adjustment during
scanning from RADF
(color)
SLG board -> SYS - -
board
Data transfer of - -
characteristic value of
scanner / SYS board -
> SLG board
Original reading start - -
sensor Auto adj.
Shading correction - -
plate
Automatic dust
detection adjustment
EEPROM initialization - -
31
RAM Contents
SYS When the value increases by "1", the copied image of
original fed from the RADF shifts toward the trailing
edge of paper by approx. 0.2 mm.
SYS When the value increases by "1", the copied image of
original fed from the RADF shifts toward the trailing
edge of paper by approx. 0.2 mm.
SYS When the value increases by "1", the carriage position
shifts by approx. 0.1 mm toward the exit side when
using the RADF.
SYS When the value increases by "1", the carriage position
shifts by approx. 0.1 mm toward the exit side when
using the RADF.
SYS Transfers the characteristic values of the scanner
(shading correction factor / RGB color correction /
reproduction ratio color deviation correction / shading
position correction factor / reproduction ratio correction
value in primary scanning direction)
SYS Transfers the characteristic values of the scanner
(shading correction factor / RGB color correction /
reproduction ratio color deviation correction / shading
position correction factor / reproduction ratio correction
value in primary scanning direction) from the SRAM of
the SYS board to the SRAM of the SLG board.
- Perform the adjustment and initialization when the
RADF board or RADF original reading start sensor is
replaced.
- Performs adjustment for automatic dust detection with
the shading correction plate. If dust is detected, shading
correction is performed by avoiding the dust.
- Initializes EEPROM for the RADF.
Proce Servic
dure e UI
1 Yes
1 Yes
1
1
6
6
6 Yes
6
6