Toshiba e-STUDIO5540C Service Manual page 288

Adjustment
In case the edges are towards the front side from (B):
Turn the stopper on the right front side clockwise to lift the equipment. The exit position will be moved
towards the rear side by approx. 0.6 to 1.0 mm for each turn.
In case the edges are towards the rear side from (B):
Turn the stopper on the left front side clockwise to lift the equipment. The exit position will be moved
towards the front side by approx. 0.6 to 1.0 mm for each turn.
Notes: Notes for installing the finisher
After the above adjustment, install the finisher according to the Unpacking Instructions.
When installing MJ-1103/1104, be sure to make the height adjustment in *29 to *30 in the
Unpacking Instructions.
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
Scale for checking the paper exit position
LT A4
( A ) ( A )
( B ) ( B )
( A ) : Recommended range ( B ) : Allowable range
Fig.8-3
Fig.8-4
Fig.8-5
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
ERROR CODE and TROUBLESHOOTING
8 - 287
8