Power Monitor - Intel Cyclone 10 GX FPGA User Manual

5 Board Test System
UG-20105 | 2017.12.18
• Detected: Displays the number of data errors detected in the hardware.
• Inserted: Displays the number of errors inserted into the transaction stream.
• Insert: Inserts a one-word error into the transaction stream each time you click
the button. Insert Error is only enabled during transaction performance analysis.
• Clear: Resets the Detected errors and Inserted errors counters to zeroes.
Address Range (Bytes)
Determines the number of bytes to use in each iteration of reads and writes.

5.3.8 Power Monitor

The Power Monitor measures and reports current power information and
communicates with the Intel MAX 10 device on the board through the JTAG bus. A
power monitor circuit attached to the Intel MAX 10 device allows you to measure the
power that the FPGA is consuming.
To start the application, click the Power Monitor icon in the BTS. You can also run the
Power Monitor as a stand-alone application. The
<package dir>\examples\board_test_system
Note: You cannot run the stand-alone power application and the BTS simultaneously. Also,
you cannot run power and clock interface at the same time.
PowerMonitor.exe
directory.
® ®
Intel Cyclone 10 GX FPGA Development Kit User Guide
resides in the
55