Skoda Octavia II 2004 Workshop Manual page 123

– Release oil check screw -B-.
– Unscrew oil drain plug -arrow- and drain all oil from the four-
wheel drive clutch.
– Screw in new oil drain plug -A- using a new sealing ring and
tighten to tightening torque.
– Unscrew fixing screws -arrows- and pull four-wheel drive
clutch out of the rear final drive.
– Remove the previously installed O-ring -arrow- from the four-
wheel drive clutch.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
– Insert a new O-ring and lightly oil with oil for four-wheel drive
clutch.
– Insert four-wheel drive clutch -1- into the rear final drive. Screw
in guide bars - T10093- for precise guidance.
– Turn at flange/propshaft -2- and insert four-wheel drive clutch
up to the stop.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
119
6. Four-wheel drive clutch