Skoda Octavia II 2004 Workshop Manual page 16

Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
3 - Diagnostic connection
❑ is located in the driver's footwell (left), next to the front flap control lever
4 - Switch for hand-brake control - F9-
❑ Fitting location ⇒ Suspension; Rep. gr. 46
❑ Check ⇒ Vehicle diagnostic tester.
❑ removing and installing ⇒ Chassis; Rep. gr. 46
5 - Brake light switch - F-
❑ Fitting location ⇒ Suspension; Rep. gr. 47
❑ Check ⇒ Vehicle diagnostic tester.
❑ removing and installing ⇒ Chassis; Rep. gr. 46
Four-wheel drive control unit - J492-
Fitting location: the control unit -A- is located on the rear final
drive, in front (left) area.
Pump for four-wheel drive clutch - V181-
Fitting location: pump for four-wheel drive clutch -arrow- is located
on the rear final drive, in front (right) area.
5.1.2 Installation location overview - electrical components, generation IV four-
wheel drive clutch, final drive 0BR, Octavia II, Superb II, Yeti, up to 10/2013
In Yeti vehicles with rear final drive 0BR, generation IV four-wheel
drive clutch was installed up to production date 10/2013. From
12
Rep. gr.00 - Technical data
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.