Skoda Octavia II 2004 Workshop Manual page 85

3.2.3 Replace front rubber-metal bearing at
the rear final drive
Special tools and workshop equipment required
♦ Mandrel - MP3-426 (30-505)-
♦ Thrust piece - MP3-417 (VW 554)-
♦ Assembly tool - MP5-400 (3416)-
♦ Assembly tool - MP5-401 (3346)-
♦ Assembly tool - MP5 402 (3301)-
♦ Interior extractor 12-16 mm , e.g. -VAS 251 601- or -Kukko
21-1-
♦ Countersupport , e.g. -VAS 251 621- or -Kukko 22-1-
Removing front bottom rubber-metal bearing
– Both ventilation pipes must be closed so that in the following
work step no oil escapes from the final drive.
– Then place the final drive with the upper part downwards onto
the work bench and pull out the rubber-metal bearing:
A - Countersupport , e.g. -VAS 251 621- or -Kukko 22-1-
B - Interior extractor 12-16 mm , e.g. -VAS 251 601- or -Kukko
21-1-
• A piece must be broken off from the collar of the rubber-metal
bearing in order to be able to position the countersupport
-arrow-.
– Insert the interior extractor into the joint of the upper and lower
rubber-metal bearing and put it under tension.
Removing front top rubber-metal bearing
Note
If the rubber metal bearing should be replaced separately, it can
also be removed with the counter support , e.g. -VAS 251 621- or
-Kukko 22-1- and interior extractor 12-16 mm , e.g. -VAS 251 601-
or -Kukko 21-1- ⇒ page 81
Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
.
Propshaft and rear final drive - Edition 10.2018
81
3. Assembly carrier