Skoda Octavia II 2004 Workshop Manual page 92

Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
When pull the propshaft off the centering stud, make sure that the
gasket ring -arrow- in the centring sleeve is not damaged.
If the sealing ring is damaged, the propshaft must be replaced.
– Tie rear end of propshaft -A-, e.g. with wire -B- to body.
– Loosen and remove nuts for propshaft flange.
A - Screw M10 x 25
B - Allen screw M8 x 15 (is screwed in from the reverse side into
the counterholder - T30004- )
C - Counterholder - T30004-
– Pull off the output flange of the rear final drive.
If there is any resistance, use three armed extractor , e.g. -VAS
251 201- or -Kukko 12-1- -A-.
88
Rep. gr.39 - Final drive - rear differential
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.