Skoda Octavia II 2004 Workshop Manual page 139

Removing
When removing the control unit -1-, the cover -2- and the disc
spring -5- are removed together. The pressure sensor -4- and the
valve -3- are removed separately.
– Switch off ignition.
– Separate plug connections -1- and -2- at the top of the control
unit.
– Place catch pan under the final drive.
– Release screws -arrows-.
Ensure that no parts fall down when removing the control unit.
– Carefully remove the control unit -A-.
– Carefully grasp the valve for control of opening degree of cou‐
pling - N373- -A- at the metal housing -arrow- using pliers and
pull out.
– Pull out pressure sensor -B-.
Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
Propshaft and rear final drive - Edition 10.2018
135
6. Four-wheel drive clutch