Skoda Octavia II 2004 Workshop Manual page 140

Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
– Pull gasket ring for control valve for opening degree of cou‐
pling - N373- -arrow- out of the housing.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
– Moisten new gasket ring for control valve of opening degree
of coupling - N373- -arrow- with oil for four-wheel drive clutch
and insert.
– Replace sealing ring -1- and -2-.
Pay attention to the different diameters:
♦ Inside diameter of gasket ring -1- is 11 mm
♦ Inside diameter of gasket ring -2- is 12 mm
– Replace O-ring -arrow A- at pressure sensor.
• The marking -arrow B- on the curved side of the disc spring
-2- points in the fitting position upwards and towards the pres‐
sure sensor -1-.
– Fit disc spring -2- with the curved side onto the pressure sen‐
sor -1-.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
136
Rep. gr.39 - Final drive - rear differential