Skoda Octavia II 2004 Workshop Manual page 120

Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
♦ Counterholder - T10172-
♦ Adapter - T10172/5-
• Rear final drive is installed.
Removing
– Raise vehicle.
NOTICE
Risk of damage to the decoupling element of the exhaust sys‐
tem.
The decoupling element must not be bent or kinked by more
than 10°.
– Do not load the decoupling element with tensile stress.
– Do not bend the decoupling element excessively.
– Separate exhaust system at the clamping sleeve and remove
bracket for the exhaust system from the assembly carrier ⇒
Engine; Rep. gr. 26 .
– Tie up pre-exhaust pipe.
– Remove the rear part of the exhaust gas system ⇒ Engine;
Rep. gr. 26 .
– Remove pendulum support from gearbox, to do so release the
bolts -B-and arrow -C-.
• Do not release screw -arrow A-.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
– Remove the heat shield -2- below the propshaft, to do so re‐
lease the screws -1-.
• After removing the heat shield screw on again by hand the
intermediate bearing of the propshaft with the screws -1-.
116
Rep. gr.39 - Final drive - rear differential