Skoda Octavia II 2004 Workshop Manual page 34

Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
– Install the propshaft on the flange of the four-wheel drive clutch
and on the flange of the angle gearbox in such a way that the
markings -arrows- are on the same line.
Observe fitting location of the different collar screws.
Collar screw with
small collar -arrow A-
large collar -arrow B-
– Align intermediate bearing in its elongated holes in such a way
that the propshaft or the intermediate bearing is not under ten‐
sion.
– Only screw down intermediate bearing after tightening the
propshaft.
When screwing the heat shield -2- with the intermediate bearing
make sure that the screws -1- are within the four centering tabs.
– Align the exhaust system, without tightening ⇒ Engine; Rep.
gr. 26 .
– Install pendulum support at the gearbox ⇒ Engine; Rep. gr.
10 .
Note
As of gearbox production date 28/05/2007, threaded inserts
♦
are located in the bolt-holes for the pendulum support (e.g.
"Heli Coil").
Identifying feature: shoulder at the first thread -arrow-. These
♦
threaded inserts can be installed with Thread Repair Kit , e.g.
-VAS 6024- .
Note the corresponding securing bolts and the tightening tor‐
♦
que for the pendulum support ⇒ Engine; Rep. gr. 10
– Install the noise insulation ⇒ Body Work; Rep. gr. 50 .
30
Rep. gr.39 - Final drive - rear differential
Fitting location
Propshaft on front final drive
-A-
Propshaft on rear final drive
-B-
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.