Skoda Octavia II 2004 Workshop Manual page 46

Propshaft and rear final drive
Hide thumbs Also See for Octavia II 2004:
Table of Contents

Advertisement

Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
Note
Do not tilt propshaft when removing, detach horizontally from
centering stud of angular gearbox and from centering stud of
rear final drive. The gasket ring/centering bushing -arrow-
must not be damaged, otherwise the propshaft has to be
replaced.
Do not bend the propshaft, only store extended and transport.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
When re-installing, fit all parts of the propshaft marked relatively
to each other in the same position.
The gasket rings -arrow- in the flanges of the propshaft must not
be damaged when removing and installing. In case of damaged
gasket rings the propshaft must be replaced.
– Push propshaft horizontally onto the respective centering
studs.
Fitting position
Three protruding bushings at the angle gearbox flange or the four-
wheel drive clutch flange and propshaft flange grip into the loca‐
tion holes of the flexible disks.
– Install the propshaft on the flange of the four-wheel drive clutch
and on the flange of the angle gearbox in such a way that the
markings -arrows- are on the same line.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
Observe fitting location of the different collar screws.
Screw
M10 x 30 with small collar ar‐
row -A-
M10 x 45 with large collar
-arrow B-
– Align intermediate bearing in its elongated holes in such a way
that the propshaft or the intermediate bearing is not under ten‐
sion.
– Only screw down intermediate bearing after tightening the
propshaft.
42
Rep. gr.39 - Final drive - rear differential
Fitting location
Propshaft on front final drive
-A-
Propshaft on rear final drive
-B-

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents