Skoda Octavia II 2004 Workshop Manual page 118

Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
6.7.3 Removing and installing V generation
four-wheel drive clutch pump, rear final
drive 0BR, Yeti from 11/2013
In Yeti vehicles with rear final drive 0BR, generation IV four-wheel
drive clutch was installed up to production date 10/2013. From
production date 11/2013, the generation V four-wheel drive clutch
is installed. Assignment ⇒ Electronic Catalogue of Original Parts
Removing
– Switch off ignition.
– Drain oil from the four-wheel drive clutch
⇒ "6.5 Drain off and fill oil for four-wheel drive clutch",
page 107 .
– Screw in new drain plug -arrow- with a new gasket ring.
– Disconnect the plug -arrow- of the pump for four-wheel drive
clutch from four-wheel drive control unit .
– Unclip electrical wiring harness -3- of the pump for four-wheel
drive clutch from the housing and expose.
– Place a catch pan under the separation point.
– Unscrew screws -1- for pump for four-wheel drive clutch .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
– Take out the pump for four-wheel drive clutch -2- from the
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
housing for the four-wheel drive clutch.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
114
Rep. gr.39 - Final drive - rear differential