Skoda Octavia II 2004 Workshop Manual page 70

Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
– After removing the heat shield screw on again the intermediate
bearing of the propshaft -arrow- with the screws -1- by hand
until the intermediate bearing can be moved.
– Remove pendulum support from gearbox. to do so release the
bolts -arrow B- and -arrow C-.
• Do not release screw -arrow A-.
– Check if a marking (colour point) is present on the flexible disk
and on the flange of the four-wheel drive clutch -arrows-. If not,
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
mark the position of the flexible disk and the flange on the four-
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
wheel drive clutch to each other -arrows-.
– Unscrew propshaft with flexible disk and oscillation damper
from rear final drive -arrows-.
66
Rep. gr.39 - Final drive - rear differential