Skoda Octavia II 2004 Workshop Manual page 33

– Unscrew rear propshaft pipe with flexible disk and oscillation
damper from rear final drive -arrows-.
– Unscrew screws -1- for intermediate bearing of the cardan
shaft from the vehicle.
– Carefully pull off the rear propshaft pipe from the centering
stud.
Note
Do not tilt propshaft when removing, pull off horizontally from
♦
the centering stud.
The gasket ring in the centering bush -arrow- must not be
♦
damaged.
The flexible disk and oscillation damper cannot be separated.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
When re-installing, fit all parts of the propshaft marked relatively
to each other in the same position.
The gasket rings -arrow- in the flanges of the propshaft must not
be damaged when removing and installing. In case of damaged
gasket rings the propshaft must be replaced.
– Push propshaft horizontally onto the respective centering
studs.
Fitting position:
Three protruding bushings at the angle gearbox flange or the four-
wheel drive clutch flange and propshaft flange grip into the loca‐
tion holes of the flexible disks.
Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
Propshaft and rear final drive - Edition 10.2018
29
1. Propshaft