Skoda Octavia II 2004 Workshop Manual page 17

production date 11/2013, the generation V four-wheel drive clutch
is installed. Assignment ⇒ Electronic Catalogue of Original Parts
1 - Four-wheel drive control
unit - J492-
❑ forms a single unit with
the control valve for
opening degree of cou‐
pling - N373- Pos. 2
❑ Fitting location
⇒ page 14
❑ Important signals are
sent from the engine
control unit and ABS
control unit with EDS to
the four-wheel drive
control unit - J104- via
the databus.
❑ Removing and installing
⇒ "6.10.2 Removing and
installing generation IV
four-wheel drive clutch
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
control unit, final drive
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
0BR, Octavia II, Superb
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
II, Yeti, up to 10/2013",
page 137
2 - valve for control of the
opening degree of the coupling
- N373-
3 - Pump for four-wheel drive
clutch - V181-
❑ Fitting location
⇒ page 14
❑ the pump can be inspec‐
ted with ⇒ Vehicle diag‐
nostic tester in the oper‐
ating mode "Targeted
fault finding"
❑ Removing and installing
⇒ "6.7.2 Removing and
installing generation IV four-wheel drive clutch pump, final drive 0BR, Octavia II, Superb II, Yeti, up to
10/2013", page 112
4 - Diagnostic connection
❑ is located in the driver's footwell (left), next to the front flap control lever
5 - Accelerator pedal position sender - G79-
❑ Fitting location ⇒ page 14
Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
13
5. Electrical components