Skoda Octavia II 2004 Workshop Manual page 137

– Press on new grooved ball bearing up to the stop.
A - Pressure plate - MP3-407-
B - Pressure spindle - T30055-
C - Pressure spindle - MP3-408-
D - Assembly tool - T10030/6-
– Insert circlip -1-.
– Centre the axial needle bearing -5...7- onto the plate clutch
-1-.
– Place the housing for the four-wheel drive clutch onto the plate
clutch -1- by hand.
• The axial needle bearings -5...7- must not change their cen‐
tered position when placing on the housing.
– Drive in new sealing ring with thrust piece - T10019- up to the
stop.
• Lightly oil new sealing ring with oil for four-wheel drive clutch
before installing.
• Keep the sealing ring straight.
Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
Propshaft and rear final drive - Edition 10.2018
133
6. Four-wheel drive clutch