Skoda Octavia II 2004 Workshop Manual page 143

– First moisten the gasket ring -1- with high-performance oil for
four-wheel drive clutch and position onto the control valve for
opening degree of coupling - N373- .
Afterwards, fit gasket rings -2 ... 4-.
• Press the centering lips (4 pieces) of the gasket ring -4- into
the groove on the valve.
– Fit new cover -2- onto the control unit -1-.
Note
The cover only fits in one position.
– Insert the control valve for opening degree of coupling - N373-
into the control unit -1-.
Note
The valve only fits in one position.
– Carefully fit on control unit -A- and tighten screws -arrows- to
tightening torque.
– Checking oil level in the four-wheel drive clutch
⇒ "6.4 Checking oil level in the four-wheel drive clutch",
page 106 .
Tightening torque
♦ ⇒ "6.2.2 Summary of components - generation IV four-wheel
drive clutch control unit J492 , final drive 0BR, Octavia II, Su‐
perb II, Yeti, up to 10/2013", page 103
6.10.3 Removing and installing V generation
four-wheel drive clutch control unit, Yeti,
from 11/2013
In Yeti vehicles with rear final drive 0BR, generation IV four-wheel
drive clutch was installed up to production date 10/2013. From
production date 11/2013, the generation V four-wheel drive clutch
is installed. Assignment ⇒ Electronic Catalogue of Original Parts
Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
Propshaft and rear final drive - Edition 10.2018
139
6. Four-wheel drive clutch