Skoda Octavia II 2004 Workshop Manual page 77

So that the rear left vehicle level sensor - G76- -1- is not damaged.
– Disconnect the plug, unscrew the sender and place down on
the bottom suspension arm -A-.
– Unscrew both drive shafts at rear final drive.
– Remove anti-roll bar ⇒ Chassis; Rep. gr. 42 .
Note
In order to unscrew and screw in the upper fixing screw
-top arrow- for the anti-roll bar clamp, remove the relevant drive
shaft from the flange shaft of the final drive and press upwards.
– Do not slacken the screw -arrow- at the front bracket more than
5 turns.
Note
The final drive is now loose.
– Raise the rear final drive -A- -arrow 1- and slide it as far to the
right as possible -arrow 2-.
– Remove the left drive shaft -B- from the flange and carefully
guide downwards.
Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
Propshaft and rear final drive - Edition 10.2018
73
2. Final drive