Skoda Octavia II 2004 Workshop Manual page 131

– Insert four-wheel drive clutch -1- with guide bars - T10093- into
the rear final drive and screw the guide bars into the holes in
the final drive.
– Turn propshaft flange -2- and push four-wheel drive clutch up
to the stop.
Tightening sequence of screws for four-wheel drive clutch.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
1. – Screw in screws -1- and -2- by hand up to the stop.
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
2. – Remove guide bars - T10093- at Pos. -3- and -4- one after the other, replace with screws and then
screw in to the stop by hand.
3. – Tighten screws to tightening torque in order in the sequence -1-, -3-, -2- and -4-.
• Tightening torque 50 Nm
– Connect plug -B- to four-wheel drive control unit - J492- -A-.
• Plug -C- is connected.
– Install propshaft to rear final drive
⇒ "1.2 Removing and installing propshaft from rear final drive",
page 21 .
– Fill oil for four-wheel drive clutch
⇒ "6.5 Drain off and fill oil for four-wheel drive clutch",
page 107 .
Tightening torques
♦ ⇒ "6.1 Summary of components - four-wheel drive clutch",
page 92 .
♦ ⇒ "5.1 Installation location overview - drain plug and check
screw", page 90 .
Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
127
6. Four-wheel drive clutch