Skoda Octavia II 2004 Workshop Manual page 135

– Support propshaft.
DANGER
There is a risk that the vehicle will fall down off the lifting plat‐
form.
If the vehicle is not securely lashed, there is a risk of the vehicle
falling down from the lift platform.
– Secure the vehicle on both sides to the supporting arms of
the lift platform.
– Lash the vehicle securely to the lift platform using tensioning
straps - T10038- .
– Loosen and unscrew nut at flange of four-wheel drive clutch.
A - Screw M10 x 25
B - Allen screw M8 x 15 (is screwed in from the reverse side into
the counterholder - T30004- )
C - Counterholder - T30004-
– Remove flange for four-wheel drive clutch.
• If there is any resistance, use the three arm puller , e. g. -VAS
251 201- or -Kukko 12-1- .
– Place a catch pan under the rear final drive.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
131
6. Four-wheel drive clutch