Skoda Octavia II 2004 Workshop Manual page 133

– Separate exhaust system at the clamping sleeve and remove
bracket for the exhaust system from the assembly carrier ⇒
Engine; Rep. gr. 26 .
– Tie up pre-exhaust pipe.
– Remove the rear part of the exhaust gas system ⇒ Engine;
Rep. gr. 26 .
– Remove pendulum support from gearbox. to do so release the
bolts -arrow B- and -arrow C-.
• Do not release screw -arrow A-.
– Remove the heat shield -2- below the propshaft, to do so re‐
lease the screws -1-.
• After removing the heat shield screw on again the intermediate
bearing of the propshaft -arrow- with the screws -1- by hand
until the intermediate bearing can be moved.
– Check if a marking (colour point) is present on the flexible disk/
oscillation damper and on the flange of the four-wheel drive
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
clutch -arrows-. If not, mark the position of the flexible disk and
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
the flange on the four-wheel drive clutch to each other
-arrows-.
Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
129
6. Four-wheel drive clutch