Skoda Octavia II 2004 Workshop Manual page 115

– Slightly lower the final drive, to do so the fixing screw must be
released by approx. 7 turns at the front bracket of the final
drive.
– Disconnect plug -arrow- for the pump from the control unit.
– Pull out wiring harness together with the holder -A- from the
housing and expose.
– Compress catch pegs -B- and push as far as possible into the
housing hole.
– Screw out the fixing screws of the pump -1-.
– Pull the pump -arrow- together with the cable protection -2- out
of the housing for the four-wheel drive clutch.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
Propshaft and rear final drive - Edition 10.2018
111
6. Four-wheel drive clutch