Skoda Octavia II 2004 Workshop Manual page 117

– Disconnect plug -arrow- for the pump from the control unit.
– Unclip the wiring harness -A- from the holders -arrows- and
expose.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
– Unscrew fixing screws -1- of the pump for four-wheel drive
clutch - V181- -2-.
– Pull the pump for four-wheel drive clutch - V181- out of the
clutch housing in -direction of arrow-, pulling through the wiring
harness -3- at the same time.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
– Replace O-rings -1- and -2-.
– Coat O-rings -1- and -2- thinly with high-performance oil for
four-wheel drive clutch .
– Fill oil for four-wheel drive clutch
⇒ "6.5 Drain off and fill oil for four-wheel drive clutch",
page 107 .
Tightening torques
♦ Rear final drive to assembly carrier ⇒ Chassis; Rep. gr. 42
♦ Pump to four-wheel drive clutch
⇒ "6.1.4 Summary of components - generation IV four-wheel
drive clutch, Octavia II, Superb II, Yeti, up to 10/2013",
page 98
Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
113
6. Four-wheel drive clutch