Skoda Octavia II 2004 Workshop Manual page 22

Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
17 - Intermediate bearing
❑ removing ⇒ page 44
❑ Fitting position ⇒ page 45
❑ installing ⇒ page 45
18 - Screw
❑ attaches additionally the heat shield
❑ 25 Nm
19 - Rear propshaft pipe
❑ when installing and removing do not damage the centering bushing and gasket ring in the middle of the
flange
20 - Screw
❑ Assignment ⇒ page 30
❑ 60 Nm
21 - Balancing nut
❑ not fitted to all propshafts
❑ if the collar screw Pos. 23 was detached, the balancing nut and the balancing washer Pos. 22 must not
be installed again
22 - Balancing washer
❑ not fitted to all propshafts
❑ if the collar screw Pos. 23 was detached, the balancing nut and the balancing washer Pos. 21 must not
be installed again
23 - Screw
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
❑ Replace after disassembly
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
❑ 50 Nm + 90°
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
24 - Flexible disk/oscillation damper
❑ Fitting position ⇒ "1.6 Removing and installing the rear flexible disk", page 46
❑ Removing and installing
25 - Rear final drive
18
Rep. gr.39 - Final drive - rear differential
⇒ "1.6 Removing and installing the rear flexible disk", page 46