Skoda Octavia II 2004 Workshop Manual page 52

Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
– Unscrew screws arrow -B- and arrow -C- of the pendulum
support.
• After unscrewing the fixing screw of the pendulum support at
the gearbox, the engine/gearbox unit is slided ahead some‐
what. Make sure that the gasket in the cardan shaft flange is
not damaged.
– Remove the intermediate bearing of the propshaft -arrow-
from the structure, to do so release the screws -1-.
– With the aid of a 2nd mechanic, press the engine/gearbox unit
forwards in -direction of arrow- and place a suitable wooden
wedge -A- (around 50 mm thick) between the assembly carrier
-B- and gearbox -C-.
– While doing so, remove the propshaft from the flange at the
four-wheel drive clutch (centering stud) on the rear final drive.
48
Rep. gr.39 - Final drive - rear differential
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.