Skoda Octavia II 2004 Workshop Manual page 136

Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
– Pull out gasket ring with ejection lever - MP3-418- .
– Remove the four-wheel drive clutch
⇒ "6.8.1 Removing and installing generation II four-wheel drive
clutch, final drive 02D, 0AV, Octavia II", page 115
– Lay four-wheel drive clutch onto a clean work bench.
– Remove housing of four-wheel drive clutch.
A - Two-arm extractor e. g. -VAS 251 001- or -Kukko 20-10-
– Install circlip -1- for grooved ball bearing -2-.
– Press off grooved ball bearing.
A - Pipe - T30034-
B - Pressure spindle - MP3-408-
C - Pressure plate - MP3-407-
Installing
• Before pressing on, heat the tapered-roller bearing e.g. with
the hot-air blower to approx. 80 °C.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
132
Rep. gr.39 - Final drive - rear differential
.