Skoda Octavia II 2004 Workshop Manual page 75

– Slacken the intermediate bearing of the propshaft from the
body by approx. 4 turns -arrows-.
– Remove pendulum support from gearbox. to do so release the
bolts -arrow B- and -arrow C-.
• Do not release screw -arrow A-.
– Check if a marking (colour point) is present on the flexible disk/
oscillation damper and on the flange of the four-wheel drive
clutch -arrows-. If not, mark the position of the flexible disk and
the flange on the four-wheel drive clutch to each other
-arrows-.
– Unscrew propshaft with flexible disk and oscillation damper
from rear final drive -arrows-.
Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
Propshaft and rear final drive - Edition 10.2018
71
2. Final drive