Skoda Octavia II 2004 Workshop Manual page 100

Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
Structure of the plate clutch
1 - Plate clutch
Plates cannot be removed.
2 - Outer rollers
3 pieces
3 - Castors
3 pieces
Installation position: roller points to the outside
4 - Castors
3 pieces
Installation position: roller points to the inside
5 - Axial needle bearing
The thick washer points to the plate clutch -1-.
6 - Axial needle bearing
The thick washer points to the plate clutch -1-.
7 - Axial needle bearing
The thick washer points to the plate clutch -1-.
6.1.3 Summary of components - generation IV four-wheel drive clutch, final drive
0BR, Octavia II, Superb II, Yeti, up to 10/2013
In Yeti vehicles with rear final drive 0BR, generation IV four-wheel
drive clutch was installed up to production date 10/2013. From
production date 11/2013, the generation V four-wheel drive clutch
is installed. Assignment ⇒ Electronic Catalogue of Original Parts
96
Rep. gr.39 - Final drive - rear differential
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.