Skoda Octavia II 2004 Workshop Manual page 98

Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
6.1.2 Summary of components - generation II four-wheel drive clutch, Octavia II
1 - Plate clutch
❑ Summary of compo‐
nents - structure of the
plate clutch
⇒ page 96
❑ Removing and installing
⇒ "6.9.1 Replacing gen‐
eration II four-wheel
drive clutch grooved ball
bearing, final drive 02D,
0AV, Octavia II",
page 128
2 - Screw
❑ 6 Nm
3 - Pump for four-wheel drive
clutch - V181-
❑ Removing and installing
⇒ "6.7 Removing and in‐
stalling the pump for
four-wheel drive clutch",
page 110
4 - O-ring
❑ Replace after disas‐
sembly
❑ ∅ 32 mm
❑ for pump for four-wheel
drive clutch - V181-
❑ coat with oil for four-
wheel drive clutch be‐
fore inserting
5 - O-ring
❑ Replace after disas‐
sembly
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
❑ ∅ 30 mm
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
❑ for pump for four-wheel drive clutch - V181-
❑ coat with oil for four-wheel drive clutch before inserting
6 - Screw cap
❑ 35 Nm
7 - O-ring
❑ for cap
❑ Replace after disassembly
❑ coat with oil for four-wheel drive clutch before inserting
8 - Oil filter holder
9 - O-ring
❑ for oil filter carrier
❑ coat with oil for four-wheel drive clutch before inserting
❑ Replace after disassembly
10 - O-ring
❑ for the oil filter
❑ Replace after disassembly
❑ coat with oil for four-wheel drive clutch before inserting
94
Rep. gr.39 - Final drive - rear differential