Skoda Octavia II 2004 Workshop Manual page 42

Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
– Unscrew intermediate bearing of propshaft from the vehicle
-arrows-.
– Guide propshaft towards the front. While doing so, slightly
press the engine/gearbox assembly forwards.
– Pull off the propshaft from the centering stud at the rear final
drive.
– Pull off the propshaft from the centering stud at the angle
gearbox.
Note
Do not tilt propshaft when removing, detach horizontally from
♦
centering stud of angular gearbox and from centering stud of
rear final drive. The gasket ring/centering bushing -arrow-
must not be damaged, otherwise the propshaft has to be
replaced.
Do not bend the propshaft, only store extended and transport.
♦
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
When re-installing, fit all parts of the propshaft marked relatively
to each other in the same position.
The gasket rings -arrow- in the flanges of the propshaft must not
be damaged when removing and installing. In case of damaged
gasket rings the propshaft must be replaced.
– Push propshaft horizontally onto the respective centering
studs.
Fitting position
Three protruding bushings at the angle gearbox flange or the four-
wheel drive clutch flange and propshaft flange grip into the loca‐
tion holes of the flexible disks.
– Install the propshaft on the flange of the four-wheel drive clutch
and on the flange of the angle gearbox in such a way that the
markings -arrows- are on the same line.
38
Rep. gr.39 - Final drive - rear differential
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.