Skoda Octavia II 2004 Workshop Manual page 91

– With the aid of a 2nd mechanic, press the engine/gearbox unit
forwards in -direction of arrow- and place a suitable wooden
wedge -A- (around 50 mm thick) between the assembly carrier
-B- and gearbox -C-.
– Remove middle and rear part of exhaust system ⇒ Engine;
Rep. gr. 26 .
– Only loosen screws for guide bearing of propshaft, do not re‐
move.
– Check if there are assembly markings (coloured points) on the
flexible disk and on the propshaft flange on the rear final drive
-arrows-.
– If there are no markings, mark the mutual positions of the flex‐
ible disk and the propshaft flange on the rear final drive.
– When loosening and tightening the screws for the propshaft,
hold the rear final drive with counterholder - T10172- with
adapters - T10172/5- .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
– Unscrew screws -arrows- of the screw connections of the
propshaft/rear final drive.
– Pull off the propshaft from the centering stud on the rear final
drive, pressing the prop slightly forward.
Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
87
4. Sealing rings