Skoda Octavia II 2004 Workshop Manual page 93

– Pull out gasket ring with ejection lever - MP3-418- -A-.
Installing
– Before installing, lightly oil outer diameter of new gasket ring
and between the sealing lips with high-performance oil for
four-wheel drive clutch .
– Drive in new gasket ring with thrust piece - T10019- up to the
stop. Do not tilt the gasket ring.
– Then screw in new nut using locking agent - D 000 600- and
tighten.
A - Screw M10 x 25
B - Allen screw M8 x 15 (is screwed in from the reverse side into
the counterholder - T30004- )
C - Counterholder - T30004-
– Connect propshaft to rear final drive
⇒ "1.3 Removing and installing propshaft", page 26
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S. – Align guide bearing in elongated holes so that propshaft and
guide bearing are free of stress.
– Install exhaust system and align free of stress ⇒ Engine; Rep.
gr. 26 .
– Checking oil level in the four-wheel drive clutch
⇒ "6.4 Checking oil level in the four-wheel drive clutch",
page 106 .
Tightening torques
♦ Nuts for propshaft flange
⇒ "1.1 Summary of components - propeller shaft", page 16
Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
.
89
4. Sealing rings