Skoda Octavia II 2004 Workshop Manual page 68

Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
❑ Tightening torque ⇒ Chassis; Rep. gr. 42
❑ Assignment ⇒ Electronic Catalogue of Original Parts
10 - Thrust plate
❑ installed between final drive and assembly carrier
11 - Stop washer
❑ fit to the rubber-metal bearing
12 - Mounting bracket
2.1.2 Summary of components - final drive 0BR, Octavia II, Superb II, Yeti
The -arrow- shows the direction of travel.
1 - Rear assembly carrier
2 - Drive shaft
❑ removing and installing
⇒ Chassis; Rep. gr. 42
3 - Rear final drive
❑ Removing and installing
⇒ "2.2 Removing and in‐
stalling the rear final
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
drive", page 65
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
❑ Replace the rubber-
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
metal bearing
⇒ "3.2 Removing and in‐
stalling rubber-metal
bearing", page 79
4 - Stop washer
❑ install on rubber-metal
bearing
⇒ "3.2 Removing and in‐
stalling rubber-metal
bearing", page 79
5 - Screw
❑ 3 pieces
❑ Tightening torque ⇒
Chassis; Rep. gr. 42
❑ Assignment ⇒ Electron‐
ic Catalogue of Original
Parts
6 - Propshaft
❑ Removing and installing
⇒ "1.3 Removing and in‐
stalling propshaft", page
26
7 - Thrust plate
❑ installed between final
drive and assembly carrier
❑ on certain vehicles 2 washers can also be present
❑ install the same number of washers as removed
8 - Stop washer
❑ install on rubber-metal bearing
64
Rep. gr.39 - Final drive - rear differential
⇒ "3.2 Removing and installing rubber-metal bearing", page 79
⇒ "3.2 Removing and installing rubber-metal bearing", page 79