Skoda Octavia II 2004 Workshop Manual page 141

– Fit new cover -5- onto the control unit -6-.
– Insert pressure sensor -4- with disc spring into the new cover
-5- and press onto the plug connection. The curved side of the
disc spring points towards the pressure sensor.
– Coat new sealing ring for pressure sensor -4- with oil for four-
wheel drive clutch.
– Insert valve -1- into the new cover -5- and the control unit
-6-. Press valve -1- onto the plug connection.
– Coat new gasket rings -2- and -3- with oil for four-wheel drive
clutch.
– Carefully fit on control unit -A- and tighten screws -arrows- to
tightening torque.
– Checking oil level in the four-wheel drive clutch
⇒ "6.4 Checking oil level in the four-wheel drive clutch",
page 106 .
Tightening torque
♦ ⇒ "6.2.1 Summary of components - generation II four-wheel
drive clutch control unit J492 , final drive 02D, 0AV, Octavia
II", page 102
6.10.2 Removing and installing generation IV
four-wheel drive clutch control unit, final
drive 0BR, Octavia II, Superb II, Yeti, up
to 10/2013
Removing
– Switch off ignition.
– Separate plug connections -1- and -2- at the top of the control
unit.
– Place catch pan under the final drive.
Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
Propshaft and rear final drive - Edition 10.2018
137
6. Four-wheel drive clutch