Skoda Octavia II 2004 Workshop Manual page 51

– Remove heat shield -2-, to do so release the screws -1-.
– After removing the heat shield screw on again by hand the
intermediate bearing of the propshaft with the screws -1-.
– Check if a marking (colour point) is present on the flexible disk/
oscillation damper and on the flange of the four-wheel drive
clutch -arrows-. If not, mark the position of the flexible disk/
oscillation damper and the flange on the four-wheel drive
clutch to each other -arrows-.
– Unscrew rear propshaft pipe with flexible disk and oscillation
damper from rear final drive -arrows-.
When loosening and tightening the screws, counterhold the prop‐
shaft on the rear final drive.
Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
Propshaft and rear final drive - Edition 10.2018
47
1. Propshaft